In this article, you will be given the steps you require in order to read Audi fault codes list properly. When your car encounters a problem which may or have damaged it, then, there will be a warning light emitted then a fault code will be stored in one or more control units within the car. Now, in order to figure out the problem occurred, then, we will need to retrieve the code first.
What to have
In order to properly read and decrypt the fault code, you will need a special scanner. Named as the On-Board Diagnostic (OBD) scanner, this kind of scanner will help you to scan any problems in the car. There are three kinds of OBD scanner based on their scanning capabilities, which are:
- Level 1 scanner, able to check the engine light.
- Level 2 scanner, able to check more issues such as CEL/ check engine light, ABS, transmission, and airbag.
- Level 3 scanner, the highest level of scanner that is able to run full diagnostics.
Indeed, figuring out the correct kind of scanner is not an easy task to fulfill. Therefore, it is a good idea to have multiple kinds of scanner at once that you can use in case one scanner is not enough. Fortunately, there are many fault code scanners out there available for scanning the Audi fault codes list.
Steps to do
Well, after you have figured out the kind of scanner to use, it is time to check the steps you need to do so that you can read the fault codes in the best way possible. Below you can read the required steps so that you can figure out the trouble hampering your car. Make sure that you perform these steps in a safe area and ask help from professionals if you require it.
The first step you need to do is to park your Audi car on a surface that is level. Then, to make sure that the car does not move on its own, you will need to set the parking brakes properly. These are important so that you can perform the next steps safely.
Now that you have parked and set the brakes, the next thing to do is to open the door of the driver and locate the OBD port. Finding the port will be easy since it is located at the lower side of the dashboard- right on your left foot when you are driving. Missing the port would not be possible and you do need to worry!
Now, you will need to plug the code scanner into the port we have located earlier. Then, start the engine of the car either by turning the key to the second position or by hitting the Start button but without hitting the pedal for braking.
Turn on the scanner then navigate to the OBD II menu. You will find the Read Codes option in it. Now, you will be able to figure out the meaning of the Audi fault codes list in no time!