FAQ: Amana Stove Error Code F9 How Do You Fix Latch?

How do I fix the F9 on my Amana oven?

F9 – Motorized Door – Check latch and replace if faulty. FF – Lock Error – Check switch and motor. Replace if faulty.

How do I reset my F9 stove?

Turn off your oven and then unplug it. Wait several minutes before you plug the appliance in once again and turn it on. This should reset the system and prompt you to reprogram the electronic control panel.

How do I fix error code F9?

The F9 error usually means the door switch circuit system is faulty. This can be addressed by checking the door switch itself. If the door switch is dirty or caught in one position, use a damp cloth to wipe the switch clean and then wiggle the switch slightly to make sure the switch moves back and forth.

Why does the oven say F9?

An F9 error code on a General Electric (GE) oven indicates that the oven’s electronic control system has detected a problem with the automatic door lock. The malfunction may be a jammed door lock mechanism, a pinched or broken wire, a faulty lock switch or a fault in the control board itself.

You might be interested:  FAQ: Error Code 651 When Connecting To Internet?

How do you unlock oven controls?

Every brand of oven is slightly different, but many have a process that will reset the oven’s computer panel and trigger the oven door to unlock. It may be something like pressing the “Clock” button and the “Clear/Off” button at the same time for 10 seconds, or holding down on the “Child Lock” button for 30 seconds.

Why is oven locked?

If your oven was locked because you accidentally started the self-clean feature, then stopped it, there is a chance that the oven will not unlock afterward. If this is your issue, the solution can be to just start the self-clean cycle and let it run until it is finished.

How do I reset my self cleaning oven?

The oven’s computer can be reset by changing the circuit breaker that controls the oven. Press the self-cleaning button again if the oven doesn’t open. If the door is unlocked after 30 seconds, cancel the cycle.

Can you adjust an oven door?

Or your hinges might be clean and functional but misaligned. Look for the bolts that secure your hinges to the door or to the oven. If they are loose, use a screwdriver or nut driver to tighten them so that the hinges are kept from wobbling and, therefore, hold the oven door in better alignment to close completely.

How do I fix my F9 Whirlpool stove?

Reset the appliance

  1. Power unit down by turning off the circuit breaker(s) for one (1) minute.
  2. Monitor the range or oven for one (1) minute to ensure the error code does not display again.
  3. Verify the range or oven operation.
You might be interested:  Often asked: Error Code 32007 When Updating Wii 2016?

How do I fix F9E0?

F9E0:

  1. Press CANCEL>CANCEL>START to enter the Diagnostics Mode and verify the failure.
  2. Unplug range or disconnect power.
  3. Verify that the house power supply provides 240 VAC between L1 and L2, and 120 VAC between L1 and N and L2 and N.
  4. Verify that the electric supply is wired correctly at the range terminal block.

How do I fix the F9 code on my Whirlpool oven?

F9 – Oven Door Lock Failure – Check door lock switches and wiring. Check for stuck lock switch. FH – Detects No Water Entering Machine or No Pressure Switch Trip – Select ‘cancel’ twice to clear this code. If there is NO water in the unit, make sure the valves are turned on all the way.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to Top