Answer: To pull the trouble codes from your 1990 through 1993 Honda Accord you’ll need to access the two wire ECU connector located near the passenger side kick panel. You will find a blue connector with one red wire and one green. You will need to insert a paperclip of metal wire between the two prongs.
How do I check the code on a 1991 Honda Accord?
You can retrieve your Honda Accord’s trouble code(s) yourself by using inserting a jumper wire at the diagnostic connector located in the passenger side kick panel. Insert the jumper wire in the 2 PIN service connector between pins 1 and 2. You should also see a 3 PIN connecter. This is used for a trouble code scanner.
How do I read my Honda ABS code?
The blinking frequency of the ABS light will indicate which code has been stored. Long blinks equal 10 and short blinks equal 1. An example of this would be three long blinks followed by one short blink. That would indicate ABS code 31.
Is a 95 accord OBD1?
OK! thanks all! you mean 94 and 95 4 cylinder accords are obd1 and all 96 and up accords are obd2. 95 v6 accords are also obd2.
How do you reset the check engine light on a 1993 Honda Accord?
EricTheCarGuy 9 years, 8 months ago. Disconnect the negative battery cable for about 30-40 seconds. reconnect it and you should be good to go.
Where is the OBD port on a 1992 Honda Accord?
Re: Diagnostic port on 92 Accord LX (jtracing) The service check connector is under the dash on the passenger side. Pic below. You jump the two wires on the plug with a paperclip or wire, then count the flashes from the check engine light.
What are the check engine codes?
The most common diagnostic codes for check engine lights are:
- Codes: P0171 – P0175 → Deals with sensing your oxygen levels.
- Codes: P0300 – P0305 → Deal with engine misfires.
- Codes: P0411, P0440, P0442, P0446, P0455 → Deal with the evaporative system.
- Code: P0401→ Deal with exhaust gas recirculation.