Question: What Is Subzero Error Code 06ec?

Cause: EC 05: Refrigerator repeatedly read erratic temperatures. EC 06: Refrigerator evaporator thermistor read open or shorted for 10+ seconds or repeatedly read erratic temperatures.

How dO you clear error codes on a Sub-Zero refrigerator?

After cleaning the condenser, press and hold the door ajar alarm key (bell symbol) on the control panel for 15 seconds to clear the error code. Only clear the error code if temperatures are near normal. If temperatures do not return to normal, or continue to rise, do not clear the error code.

How dO you reset a Sub-Zero refrigerator?

To reset a Sub-Zero product:

  1. Turn the unit off at the control panel. For units with a dial control, turn the knob to zero (0) or off.
  2. Turn the home circuit breaker to the unit off for 30 seconds and back on again. Retest the unit operation.

Why is my Sub-Zero refrigerator beeping?

If the beeping noise occurs when the door is open, this may be the door ajar alarm. To confirm, disable or turn off the door ajar alarm. For instructions on how to turn the door ajar alarm on or off, review information for the specific product: Built-In.

You might be interested:  FAQ: What Error Code Do You Get For Dividing By Zero In C++?

What does EC mean on Sub-Zero freezer?

EC 20. Defrost underheat. This error may indicate an issue with the wiring, defrost heater, defrost terminator, or refrigerator control board. If you receive this error, contact your local Sub-Zero repair service for assistance.

dO Sub-Zero refrigerators run all the time?

Sub-Zero runs all the time and temperatures are normal. Does a refrigeration product work better with a lot of food in it. Do empty refrigerators or freezers affect performance. Too much food in a refrigerator, unit is warm.

What temp should Sub-Zero freezer be?

The best temperature for your Sub-Zero refrigerator is 38 degrees Fahrenheit and the freezer should be set to 0 degrees. However, fluctuations between -/+ 5 degrees are normal.

How do you troubleshoot a Sub-Zero refrigerator?

For an Existing Sub-Zero Refrigerator

  1. Check the setpoint temperatures for the compartment.
  2. Verify the door closes and was not left ajar for a long time.
  3. Correct or remove anything blocking the door from closing.
  4. Check the door gasket or rubber for damage.
  5. New groceries or warm food will raise temperatures for a time.

How do I turn off my freezer Sub-Zero?

To turn off the refrigerator and freezer, turn the control knob to 0 or off. If the lights stay on in the unit or the condenser fan motor continues to run after the dials are turned to the off position, turn the unit off at the circuit breaker.

Why did my Sub-Zero freezer stop working?

Fan not working properly. Temperature sensor or thermostat malfunction. Sealed system problem. Door seal or gasket issue.

You might be interested:  Often asked: How Do I Fix Error Code Dns_probe_finished_bad_config?

Why is my wolf range beeping?

Ovens chime to alert the user when timers expire, when the oven reaches setpoint temperatures, and at other intervals depending on model number. If an oven chimes or beeps unexpectedly: Turn the unit off. Turn the power to the circuit breaker for the product off for 30 seconds, then turn it back on.

How do you turn off the ajar alarm on a Frigidaire freezer?

Door Ajar. Frigidaire freezers and refrigerators sound an alarm if the door stays open for more than five minutes. When it sounds, the unit’s display will tell you that the door is open, so you know which alarm is beeping. To stop the alarm, press the “set’ or “alarm reset key” once.

How dO you reset the service light on a sub-zero?

Turn the unit off for 10 seconds. Turn the unit back on. If only “SERVICE” is flashing and “ICE” is solid, see Sub-Zero with “Service” Flashing. If this recurs frequently in a short time, contact Factory Certified Service.

How dO I reset my Subzero alarm?

Power down the unit at the control panel using the unit on/off button. With the unit off, monitor for 15 – 30 minutes to see if the beeping continues. Restore power to the unit. If the beeping continued with the power supply to the unit turned off, the noise is not coming from the refrigerator.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to Top