Quick Answer: How To Find Error Code On A Duet Washer?

Duet Washer error and fault codes are displayed by alternating F#__ and E#__ The F error describes the washer system and the E error further defines the washer part that may be having a problem. F1, F2, F6 Are main control and program faults. F3 faults are washer sensor related problems.

How do you run a diagnostic on a Whirlpool Duet washer?

Whirlpool Duet Diagnostic Test Mode Close the washer door. Select any one key except “Stop/Cancel” and Control Lock. If you got it right all the lights on the Duet washer’s control should light up, and any error codes in the washer’s memory will be displayed.

Is there a reset button on a Whirlpool front load washer?

Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.

How do I reset my Whirlpool Duet front load washer?

Unplug the washer for 30 seconds to attempt to reset the Duet washer control. if your fill hoses have a flood stop check valve turn the water off, disconnect the hoses and run a little water into a bucket. Then reconnect the hoses to your washer and do a Duet Washer Quick Diagnostic Test.

You might be interested:  Question: How To Fix Windows Error Code 80070422?

How do you clear the error code on a Whirlpool front load washer?

To remove the code, press pause or cancel button twice and the power button once. If the code is still displayed, unplug the washer or disconnect the power for one minute. Items were detected in the washer during the Clean Washer cycle. Remove items from the drum and restart the Clean Washer cycle.

How do I fix a Whirlpool washer error?

Manual Review

  1. Unplug the Whirlpool washing machine from the mains.
  2. Wait for 15-20 minutes while the control unit reboots.
  3. Reset the error by pressing the START button (On/Off).
  4. Check hatch locking.

What does the Code F mean on a Whirlpool washer?

The F/dL code indicates a door lock error on the machine. When the door fails to lock to allow the cycle to begin, it attempts to lock itself at least six times before the error appears on the digital display screen. When the door fails to lock, the machine won’t run at all.

How do you reset a front load washer?

How to reset the washing machine:

  1. Press POWER to turn the washer off.
  2. Unplug the washer from the power outlet or turn the circuit breaker to the unit off.
  3. With the power disabled, press and hold the START/PAUSE button for 5 seconds.
  4. Plug the washer back in, or turn the circuit breaker back on.

Why is my washer just sensing?

If the water level seems too low, or if the washer does not fill completely, auto-sensing helps stabilize the amount of water used. The washer senses the size of the load and adds the correct amount of water for the load size. You may notice during a cycle that the wash load is not completely submerged in water.

You might be interested:  Readers ask: What Does Error Code 4e On A Samsung Refrigerator?

What does F5 mean on my washing machine?

The F5 error code indicates that the Central Control Unit (main machine control board) detects a temperature sensor resistance that is out of the normal range. The F5 error is normally caused by a failed NTC temperature sensor.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to Top