Readers ask: How Can I Get The Error Code To Display On My Bosch Dishwasher?

How do I find the error code on my Bosch dishwasher?

Error codes for Bosch display dishwashers. Error codes are shown in alphanumeric format E on Bosch dishwashers screen; At the same time, some models display the prefix “E” instead of the “F” one.

How do you reset the code on a Bosch dishwasher?

To reset the modern Bosch dishwasher, press and hold the start button for about 3 to 5 seconds. On some older Bosch models, the reset feature may be called “cancel” or “drain”. These older models require a specific Button Press Sequence or what we in the biz call a Key Dance to complete.

Why is my Bosch dishwasher blinking 01?

If a Bosch dishwasher displays the error code e01, it means the control panel is malfunctioning. If the dishwasher does not work at all or fails, the faulty control board is probably the case. It controls all the functions.

How do I troubleshoot my Bosch dishwasher?

Reset the dishwasher by pressing and holding the "Start" button for at least three seconds. Depending upon the Bosch dishwasher model you have, you also can push the "Cancel-Reset" button to reset the dishwasher. Select a new cycle and press "Start."

How do you run a diagnostic test on a Bosch dishwasher?

For many Bosch dishwashers, this is done by pressing the "start" button and waiting for a response. If this doesn't cause the cycle to resume or fix the problem, press and hold the "start" button for three to five seconds, then wait to see whether this works.

How do I change the settings on my Bosch dishwasher?

Open the dishwasher door and press the "On/Off" button. Press and hold the "A" button and press "Start" until "H:00" appears. Release the buttons and press the " B" button until the desired setting is reached.

How do you clear a dishwasher error code?

Sometimes disconnecting power to the dishwasher for 30 seconds will clear the fault, error or function code.

How do I fix E14 error on my Bosch dishwasher?

Bosch dishwasher has a water flow sensor, and if it breaks, the self-diagnosis system displays the E14 error. Replacing the valve is easy:

  1. disconnect the wiring from the detail;
  2. remove the fixing screw.
  3. replace the detail with the new valve.

What does cleaning display light mean on Bosch dishwasher?

it's just an indicator that the load is now clean.

Why does my Bosch dishwasher keep saying check water?

A Bosch dishwasher check water and rinse aid light flashing may indicate that the anti-flood switch has been activated. This is often caused by a blocked drain or a faulty drain pump, and you may find water leaks under the machine.

Is there a reset button on a dishwasher?

Can you reset your dishwasher? Yes, you can reset your dishwasher by pressing the Start/Reset button on the appliance and waiting a few minutes. If your dishwasher still doesn't start, you may need to reboot the entire system by turning off power to the appliance at the house circuit breaker or fuse box.

How do I know if my Bosch dishwasher pump is bad?

To check this, run your dishwasher and see if water pooled at the bottom of the washer. If you notice a large puddle there, you probably have a pump motor problem. When your dishwasher is draining, you hear a high-pitched whining noise. The whining noise tends to be the sound of a dying motor or a jammed pump.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to Top