What Does The Error Code Cl Mean For A Lg Dryer?

A CL code or CHILD LOCK reading on the dryer’s display is not actually an error code, but rather an indication that the Child Lock feature is active. For most models, press and hold the key labeled CHILD LOCK for 3 seconds to disable the Child Lock feature.

How do I turn off the control lock on my LG washer?

Once LG is powered ON, go to the right touch-screen panel, press and hold “Pre-wash + Delay wash” buttons simultaneously for 3-5 seconds. This will turn OFF the CL (control lock/child lock).

How do I reset the CL on my LG dryer?

For most models, press and hold the key labeled CHILD LOCK (secondary function) for 3 seconds to disable the Child Lock feature. Keep pressing & holding down button until CL indication disappears or LOCK icon turns off on the display panel. Unplugging the dryer & plugging it back in will not reset the LOCK function.

Is there a reset button on my LG washer?

If your LG washing machine won’t start, try doing a hard reset on the unit. To perform a reset, start by unplugging your washer. Then, press and hold the power button for 5 seconds. Do the same with the play button.

You might be interested:  Readers ask: What Is Error Code Caterpillar?

How do I get the control lock off my washing machine?

Select and hold END OF CYCLE SIGNAL for 3 seconds. The CONTROL LOCKED status light glows. Select and hold END OF CYCLE SIGNAL for 3 seconds until the CONTROL LOCKED Status light turns off. I hope this is helpful.

How do you clean the humidity sensor on a LG dryer?

Instructions: how to clean your dryer’s moisture sensor

  1. Locate your dryer’s moisture sensor.
  2. Take your fine sandpaper and scrub the moisture sensor.
  3. Take your dry rag and polish up the moisture sensor.
  4. Test your dryer to be sure it’s working properly.

How do I turn off the control lock on my dryer?

Press and hold the Extended Tumble and – (minus) buttons for 3 seconds. The control lock icon will flash while locking/unlocking, stay on when locked, and turn off when unlocked. NOTE: The Power button can still be used when the machine is locked.

How do I troubleshoot my LG dryer?

How to Troubleshoot a LG Dryer

  1. Inspect the dryer vent to ensure it is clear of lint and debris.
  2. Check the LG dryer power breaker at the lighting panel, when your unit will not start.
  3. Inspect the inside face of the door, and remove any lint buildup around the door’s seal that may prevent it from closing completely.

What does it mean when my LG Dryer says check filter?

What is this? ‘Check filter’ is not an error message but a routine message that shows up before every drying cycle. The only filter error message that you will see is F0(Filter out). This error means that the lint filter has not been appropriately inserted into the machine.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to Top