What Is Error Code He On Samsung Dryer?

The Samsung dryer error code HE is an error code of the dryer caused by the absence of the heat stream to the drum with the wet laundry.

How do I fix the HE error on my Samsung dryer?

Heating errors (HC, hE, HC4, 1 HC) The most common cause is a clogged lint screen or vent system trapping heat in the dryer. Clean the lint screen, vent system, or both to correct the error.

How do I reset the code on my Samsung dryer?

Resetting your dryer is easy. Unplug it (or turn off power at the circuit breaker), wait some time for the electrical charge to clear out of the dryer (usually 1 to 5 minutes at most), and then power it up again. That’s it. That’s all it takes to reset.

How do I turn off the HC code on my Samsung dryer?

To reset this you usually just need to run a smart check on it. Press and hold the Timed button and the Mixed Load Bell button for several seconds and this will run a smart check on the dryer and it should clear any error codes stored in there.

You might be interested:  Question: What Is The Error Code E1f5 On A Whirlpool Oven?

How do I run a diagnostic on my Samsung dryer?

Run a Vent Blockage test

  1. When you’re ready to start, make sure the drum is empty and then close the door.
  2. Press POWER to turn the dryer on and within 5 seconds, press and hold Adjust Time Up + Dry Level until InS or In appears on the display.

Where is the dryer reset button?

Often, dryers are equipped with a reset button on the control panel.

What would cause my Samsung dryer to not heat up?

If your Samsung dryer is not heating up, in 80% of the cases it is caused by a burnt heating element, the other 18% being a blown thermal cut-off fuse, cycling thermostat, or a failed control board heater relay. The last 2% caused by an improper power supply.

How do you check the moisture sensor on a Samsung dryer?

The sensor bars can be also tested in diagnostic mode. Place a slightly damp cloth in the dryer, start a normal cycle then press the Temp + Signal buttons for 3 seconds. When there are wet items being dried, data will add up (from 0 to 1200 and repeating) as the wet clothes touch the sensor bars.

What does HC mean on Samsung washer dryer?

Samsung error HC or HE The hot air compressor may be overheated. Turn off the dryer for 20 minutes. Turn on the dryer and restart the cycle.

Do Samsung dryers have problems?

Samsung dryers are generally reliable, but when something goes wrong it can bring your entire laundry routine to a grinding halt. Samsung dryer problems might include a faulty heating element or a broken drum spider. Maybe you don’t even know what that is, but you will by the time you’re done replacing it.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to Top